PhidgetStepper Unipolar 4-Motor

  • PrinzFritz
  • PrinzFritz's Avatar Topic Author
  • Visitor
  • Visitor
20 Jul 2010 11:16 #3426 by PrinzFritz
PhidgetStepper Unipolar 4-Motor was created by PrinzFritz
hi,

is there the possibility to use the PhidgetStepper Unipolar 4-Motor with emc?

i have no oldschool-pc, but netbook with usb,

and my little desktop-mill take this great Stepperboard ...

sorry for my bad english :o)

Please Log in or Create an account to join the conversation.

More
20 Jul 2010 18:38 #3431 by PCW
No, EMC does not currently support USB motion control devices because
USB based motion control devices are not realtime and therefore compromise EMCs capabilities

Please Log in or Create an account to join the conversation.

  • PrinzFritz
  • PrinzFritz's Avatar Topic Author
  • Visitor
  • Visitor
21 Jul 2010 10:49 #3440 by PrinzFritz
Replied by PrinzFritz on topic Re:PhidgetStepper Unipolar 4-Motor
mh .. so i think emc is not for today-pc ... ?

I find that very sad ...

the Hardware-List is to old .. is far too expensive and for a real hobby not the right ... very sad ...

at this time are so many tiny solutions like desktop-mill and the most have usb ...

so as a layman i think that emc is to old ... ? maybe ...

sorry for my bad english ;o)

Please Log in or Create an account to join the conversation.

Time to create page: 0.122 seconds
Powered by Kunena Forum