Moving setup-files to another computer

More
08 Oct 2017 21:09 #100097 by Stonefire
Hi

Newbie need help to move setup to another computer.
My old computer with ver2.6 was to slow. So I've got a new and installed ver2.7, but how do I move my setup to the new computer ?

Sincerly
Steen

Please Log in or Create an account to join the conversation.

More
09 Oct 2017 01:50 #100104 by Todd Zuercher
I'd start by copying the "linuxcnc" folder in your home directory from your old computer to your new one. That should move all of your old configuration files from the old to new.

There are also a couple of minor changes that may need to be made to your hal files. They are coverd here.
linuxcnc.org/docs/html/getting-started/updating-linuxcnc.html
The following user(s) said Thank You: Tchefter

Please Log in or Create an account to join the conversation.

More
09 Oct 2017 07:29 #100112 by Stonefire
Hi Todd

Thanks!
!'ll try that...

Sincerly
Stonefire

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 14:38 #100143 by Stonefire
Hi Todd

That went ok, but now my x- and Y-axis is turneded around, and I can't recall how to change it. I'ts is more than 3 years since I set my cnc up...

Sincerly

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 14:48 #100144 by Todd Zuercher
X and Y switched or just moving the wrong way?

There are lots of ways to change these, and the simplest solution will depend on how your machine is configured.
To change the direction of a step/dir config, you can usually just invert the dir pin.

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 15:08 #100148 by Stonefire
Also got this error:
RTAPI:ERROR: Unexpected realtimedelay on task 1...

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 15:11 #100149 by Stonefire
;-) both - I belive I did it once in one of the config-files, but can't recall wich one....

Sincerly

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 17:35 #100156 by Todd Zuercher
If you have more than one config file, then the one that is right is probably still there, keep trying different ones until you find the one that is right.
(If you look at file dates it is probably the newest one.)

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 18:02 #100157 by Stonefire
Thanks, but is it a ini or a hal-file ? do you know ?

Sincerly

Please Log in or Create an account to join the conversation.

More
10 Oct 2017 18:57 #100160 by Stonefire
Hi Todd
Got it all working again, except the strange Rtapi-error

Sincerly

Please Log in or Create an account to join the conversation.

Time to create page: 0.167 seconds
Powered by Kunena Forum