Duet3 as hardware for LinuxCNC?
- hans22
- Offline
- New Member
-
Less
More
- Posts: 1
- Thank you received: 0
26 Oct 2024 06:03 #313240
by hans22
Duet3 as hardware for LinuxCNC? was created by hans22
I happily found Duet3 to be powerful enough to drive the
stepper motors
of my mill. As a Linux enthusiast I am very happy about LinuxCNC and would like to use that via the Duet board to control my motors, i.e. also with LinuxCNC-generated G-code.
Possible? Already done?
Possible? Already done?
Please Log in or Create an account to join the conversation.
- Aciera
-
- Offline
- Administrator
-
Less
More
- Posts: 3946
- Thank you received: 1705
26 Oct 2024 06:33 #313241
by Aciera
Replied by Aciera on topic Duet3 as hardware for LinuxCNC?
The same question (but with a different link embedded):
forum.linuxcnc.org/additive-manufacturin...ples?start=10#243250
forum.linuxcnc.org/additive-manufacturin...ples?start=10#243250
Please Log in or Create an account to join the conversation.
Moderators: piasdom
Time to create page: 0.047 seconds