Thanks for having me!

Just wanted to say thank you for having me! Look forward to retrofitting my new machine for use with LinuxCNC!

Welcome
what machine
and how can we help
we are all over the world
i am in Germany/Europa

Welcome

Any new updates of your new machine?

OK,
Looking at you how you are proceeding the project!
Best wishes!

Thanks pl7i92 ChrisCandee EddieSpike DinukaShehan !!!

My project is moving forward, although very slowly!

ProjectPrecix

When I purchased the CNC I was told the spindle VFD could run on single phase or three phase, well, that particular VFD requires 3 phase. So I had to move the CNC to a different location, so that has taken some time as that table is heavy!

I am now resetting up the CNC to get as far as I was before, I was getting very close to getting LinuxCNC to open, so excited to get back to that state. Hopefully this weekend I can use the Mesa to move a servo motor! Doesn't sound like much, but so excited!!! haha...

Hopefully I will update my project thread soon...
New location... Basement... three phase is nearby though!

Sorry BigJohnT,

I was just using this thread to say, thanks for having me, I got my other thread where I am getting some help and showing off what I am doing, so you can kill this thread if you'd like.

Thanks for everyone's help!