CPLD for GPIO

No eBay APP ID and/or Cert ID defined in Kunena configurationNo eBay APP ID and/or Cert ID defined in Kunena configurationIs possible to connect a cheap cpld like these


with serial interface to linuxcnc ?
Α real time serial link with a mesa card ?
These boards are very cheap and have a lot of i/o

question misunderstood - original reply withdrawn

question misunderstood - original reply withdrawn

You probably could use one of those as I/O expansion
for a Linuxcnc/Machinekit host that has a SPI port
(BeagleBone, CubieBoard, RasPI etc) or a mesa card with SPI firmware but you would need to do driver work (or component work for Mesa)
to get SPI access from HAL

Not as cheap but if you want TTL level GPIO expansion from a Mesa system,
a 7I90 running SSREMOTE firmware works (72 five volt tolerant real time I/O bits, long distance capable RS-422 link)

question misunderstood - original reply withdrawn

I want to use a core for UART from web and mesa_uart component.
Anyway this is for experimenting not for a working machine. For a real machine i will get something that works like 7i90.

PCW wrote: Not as cheap but if you want TTL level GPIO expansion from a Mesa system,
a 7I90 running SSREMOTE firmware works (72 five volt tolerant real time I/O bits, long distance capable RS-422 link)

7i90HD is very nice and cheap but out of stock.. I hope until my next next order from mesa to be stocked again.

The 7I90HD should be available in a couple of days

HI PCW, how to setting baurate for 7i90 run ssremote

As a standard SS remote device, the 7I90 runs at 2.5 MBaud. This is not changeable with the current firmware.

Thanks PCW, let me try