select jog axis

setp halui.feed-override.direct-value 1 setp halui.feed-override.count-enable 1 setp halui.feed-override.counts 8 setp halui.feed-override.scale 0.1 if i do setp halui.feed-override.counts 8 in halshow then it changes on AXIS UI, but why it doesn't work from hal file? Also i have tried to do this from post_gui.hal same result POSTGUI_HALFILE = postgui.hal What is proper order to load those?

loadrt mux8 count=1 loadrt select8 count=1 loadrt conv_float_s32 names=pen-conv-float loadrt conv_s32_bit names=pen-conv-s32 addf mux8.0                   servo-thread addf select8.0                servo-thread addf pen-conv-float           servo-thread addf pen-conv-s32             servo-thread #Axis Select (0=off, 1=x, 2=z, 3=y, na, 5=6, 6=4, 7=5)  setp mux8.0.in0 0 setp mux8.0.in1 1 setp mux8.0.in2 2 setp mux8.0.in3 3 setp mux8.0.in4 4 setp mux8.0.in5 5 setp mux8.0.in6 6 setp mux8.0.in7 7 net mux8-sel0 <= hm2_7i76e.0.7i76.0.0.input-13 net mux8-sel1 <= hm2_7i76e.0.7i76.0.0.input-14 net mux8-sel2 <= hm2_7i76e.0.7i76.0.0.input-15 net mux8-sel0 => mux8.0.sel0 net mux8-sel1 => mux8.0.sel1 net mux8-sel2 => mux8.0.sel2 setp pen-conv-float.clamp 0 net mux-float <= mux8.0.out net mux-float => pen-conv-float.in net mux-s32   <= pen-conv-float.out net mux-s32   => select8.0.sel net axis-select-x <= select8.0.out1 net axis-select-y <= select8.0.out3 net axis-select-z <= select8.0.out2 net axis-select-a <= select8.0.out6 net axis-select-5 <= select8.0.out7 net axis-select-6 <= select8.0.out5 net axis-select-x => axis.x.jog-enable net axis-select-x => halui.axis.x.select net axis-select-y => axis.y.jog-enable net axis-select-y => halui.axis.y.select net axis-select-z => axis.z.jog-enable net axis-select-z => halui.axis.z.select net axis-select-a => axis.a.jog-enable  net axis-select-a => halui.axis.a.select net axis-select-5 => halui.feed-override.count-enable  net axis-select-6 => halui.rapid-override.count-enable