another way to interface panel then 7i73

Greetings all, Due to unavailability of 7i73 i would like to know there is any other way to interface Control panel IO with linuxcnc

7i84 can also be used, but does not support LCD screen.
It does have 2 MPG inputs, 4 analog inputs at VField (8-32V) i think, but you should check that, over a year since i used those, although i have 2 of them and a 7i73.

There are a number of projects out there that use an Arduino as a panel interface.

We should have more 7I73s in a week or so

Yes i was also thinking about to 7I84D with matrix_kb or STM32 black pill but i have no idea about how to make it work with SSerial.

Sounds good i think i could wait for week and could you confirm 7I69 and 7I84(not D) ?

No 7I69s (though these can be replaced with a a7I90HD)
We have some 7I84s

@PCW i am planing to purchase one of this combination but 7I80HD-25 and 6I24-25 are not available so is any possibility i could purchase this week or next ? coz 5I24-25 is on last in priority

Combination 1
2 X 7I80HD-25
2 X 7I52S
2 X 7I52
2 X 7I84D(X3)
Combination 2
2 X 6I24-25
2 X 7I52S
2 X 7I52
2 X 7I84D(X3)
Combination 3
2 X 5I24-25
2 X 7I52S
2 X 7I52
2 X 7I84D(X3)

 

The 5I24-25 is the only 50 pin FPGA card we have currently
(other than PC104-PCI cards) It will be at least a few months
before we have replacements as they require re-design around
available FPGAs

Well mesaus hase 2 7I80HD-25 could you get from them and sell us ?
mesaus.com/product/7i80hd-25/