LinuxCNC error

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284208 by tda2261

LinuxCNC error was created by tda2261

I am getting an error code when loading up LinuxCNC. I have the mesa boards installed. Error code: ' /usr/realtime-3.4.55-rtai-2/modules/linuxcnc/hm2_7i43.ko' : -1 Input/output error. could someone help me troubleshoot the error?

Please Log in to join the conversation.

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284210 by tda2261

Replied by tda2261 on topic LinuxCNC error

let me know if you need any images

Please Log in to join the conversation.

tommylight
Offline
Administrator

2 years 11 months ago #284213 by tommylight

Replied by tommylight on topic LinuxCNC error

Error report, especially the debug part.

Please Log in to join the conversation.

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284246 by tda2261

Replied by tda2261 on topic LinuxCNC error

Debug information:

Attachment not found

Last couple of lines:

Attachment not found

Please Log in to join the conversation.

tommylight
Offline
Administrator

2 years 11 months ago #284250 by tommylight

Replied by tommylight on topic LinuxCNC error

Moved to "driver boards".

Please Log in to join the conversation.

PCW
Offline
Platinum Member

2 years 11 months ago #284258 by PCW

Replied by PCW on topic LinuxCNC error

LinuxCNC did not find the 7I43 card.
some possible causes are:

7I43 not in EPP mode (7I43 jumper setting)
No 5V power to 7I43
Bad 7I43
Bad parallel cable or 7I43 not connected
Parallel port not in EPP 1.9 mode (BIOS setting)
Bad parallel port

Please Log in to join the conversation.

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284328 by tda2261

Replied by tda2261 on topic LinuxCNC error

How do I check or change it into EPP mode?

Please Log in to join the conversation.

PCW
Offline
Platinum Member

2 years 11 months ago #284330 by PCW

Replied by PCW on topic LinuxCNC error

How do I check or change it into EPP mode?

On the 7I43, W4 and W5 down,
On the BIOS it depends but there is usually an I/O setup section
and you can select the parallel port address and operational mode.

Is the 7I43 connected to a motherboard parallel port connector?

Please Log in to join the conversation.

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284337 by tda2261

Replied by tda2261 on topic LinuxCNC error

I found that it was in ECP mode in BIOS. I changed it EPP.

The board looks correct, do i need to change anything?

Please Log in to join the conversation.

tda2261
Topic Author
Offline
New Member

2 years 11 months ago #284340 by tda2261

Replied by tda2261 on topic LinuxCNC error

i am still getting an error after

Please Log in to join the conversation.

Time to create page: 0.403 seconds