Pointer not jogging on linuxcnc axis ui

I am trying to set up thc toma on my plasma machine..
Any tips would be appreciated
When i jog machine is jogging but my cone shaped pointer in axis ui is not movinr
Also when i run a gcode only z axis works no x or y motion
Can someone help me?? "

hi
did you setup the ini
with GEMOTRY = XYZ

is there a Startup code in the INI
RS274NGC_STARTUP_CODE = G17 G20 G54 G40 G49 G64 P0.001 G80 G90 G92.1 G94 G97 G98

hard to belive
what system are yo using
2.7 2.8 2.8
and os wheezy mint stretch

Hello sir eagerly waiting for your reply ☺
I'm using debian 9 with linuxcnc thc toma
At start it says joint2 on limit switch error so i removed neg and pos components lim from hal
My problem is when i run gcode it stuck at line 3 not moving forward
If i do run from some next line the x and y axes run but thc not working as torch not starts my gcode file has no z axis...
And if i add m3 torch on to the same line the thc works but its not moving to the next line

Stuck at line 3
I do run from 41 running normally without m3 and torch also not starting
I insert m3 and torch working but xy not moving
Its just do endless probing type something

get
G17 G54
into first line
use
T1 M6
bevore S3400
WHY 3400 that means running on 340 V
i use S112
M3 on separate lines

I ended up with this error

Its not moving forward this line

ARCOK signal is not wired or has to be set as NOT in hal.
Also you have Z values in that file and very wrong one at that as you have Z-.1f24 ????? How did you get that value? Nevermind, just delete lines with Z values.
THC_toma will not move the machine without a propper ARCOK signal.
S value can be any number.

Sir will u kindly explain what do you Mean by wrong z values??

In your gcode you have a value of Z-.1f24
That is not a valid value.

And having 5 threads for the same problem is not helping.