REMAP function doesn't work

I try to study REMAP function and I read main Doc (Example for named parameter passing to NGC procedures)
but I get such error:
"NGC file not found: ngc=m400 - 45:REMAP = M400 modalgroup=10 argspec=Pg ngc=m400"

I make standart example:
1) I add to .ini file in [RS274NGC]
REMAP=M400 modalgroup=10 argspec=Pq ngc=400
2) Creat file <m400.ngc> in main linux configuration folder (also change it to standart nc-files
2.1) The code of it is from example: 3) linux doesn't starts.

aleksamc wrote: "NGC file not found: ngc=m400 - 45:REMAP = M400 modalgroup=10 argspec=Pg ngc=m400"

You need to have actual files named m400.ngc in the same folder as the config, if i remember correctly as it was some years ago i used remap.

Yes, I have them in the same folder as .ini file, but it doesn't found it.
What I do wrong I don't know?

Pretty sure your 400.ngc file needs to be saved in the location specified under the SUBROUTINE_PATH parameter in the [RS274NGC] section of your INI file.

Yes, it's helped. Thanks a lot.

-

I try to continue my study of remap.
Now I stuck at python runnig program (first example)
1) In .ini file I write
REMAP=G88.6 modalgroup=1 argspec=XYZp python=g886
2) Then I created file g886.py in the same directory as ngc remapping files.
3) In file I write my program from standart example
4) I've got an error: I get such error if I complitly delete file from the folder also.
What problem could be?

I've read "4. Upgrading an existing configuration for remapping"


but still have problem

Can you post your python code?

I added all necessary files. Now I'm very bad in python but I hope to study it using examples in technical docs.



What editor Can I use to write program for python? Using it in gedit is very inconvenient.

I may be mistaken but I believe your return needs to be indented on line 10.

Editor personal preference for general python is atom for generic writing, and pycharm for extreme debugging, but it doesn't work as nice when using linuxcnc