error finishing read

More
3 years 7 months ago #267157 by CNC_ANDI
error finishing read was created by CNC_ANDI
Hello,

Today i´ve become for the first time the following error.

 

Attachment not found



at the time where i get this error the machine was not working... the programm before was runing fine

 

Please Log in to join the conversation.

More
3 years 7 months ago #267161 by PCW
Replied by PCW on topic error finishing read
This indicates a real time issue with network communications
(too many timed out packets)

FIxes

Use as better kernel

Best is 4.19 next best is 6.X 5.X are mostly terrible

Lower the servo thread rate (to say 2000000 ns)

Please Log in to join the conversation.

More
3 years 7 months ago #267163 by CNC_ANDI
Replied by CNC_ANDI on topic error finishing read
ok so i will test a 4.19 or a 6.x kernel...

thx

Please Log in to join the conversation.

More
3 years 7 months ago #267168 by PCW
Replied by PCW on topic error finishing read
I should also mention that if you have a Intel MAC
you need to disable IRQ coalescing as described
in the hm2_eth manual page.

Please Log in to join the conversation.

More
3 years 7 months ago #267172 by CNC_ANDI
Replied by CNC_ANDI on topic error finishing read
yes i know. i think i was doing this at the installation.... the system running for few times.

Please Log in to join the conversation.

More
3 years 7 months ago #267199 by rodw
Replied by rodw on topic error finishing read
Try Debian Bookworm which puts you on the 6.1 kernel
Follow my guide linked here.
forum.linuxcnc.org/9-installing-linuxcnc...g-installation-notes
Its hard to recommend going back to the 4.x kernel as a lot of later hardware is not supported.

Please Log in to join the conversation.

More
3 years 7 months ago #267245 by CNC_ANDI
Replied by CNC_ANDI on topic error finishing read
hi, i have a second pc already installed with debian bookworm and Porbe_basic....

My machine pc is installed with debian bullseye.... can i install the 6.xx kernel on debian bullseye to?

i will try it. so i have a backup pc :)

Please Log in to join the conversation.

More
3 years 7 months ago #267264 by rodw
Replied by rodw on topic error finishing read
You can try it. If it does not work out you can revert to your previous kernel by selecting a different option in Grub

Please Log in to join the conversation.

More
3 years 7 months ago #267307 by CNC_ANDI
Replied by CNC_ANDI on topic error finishing read
can´t find a 6.x rt kernel for debian bullseye. i will try the debian bookworm pc later.

Please Log in to join the conversation.

More
3 years 7 months ago #267311 by rodw
Replied by rodw on topic error finishing read

can´t find a 6.x rt kernel for debian bullseye. i will try the debian bookworm pc later.
You cold try the image and header files from here
drive.google.com/drive/folders/10uwGg5Rv...k16na?usp=share_link

Please Log in to join the conversation.

Time to create page: 0.116 seconds
Powered by Kunena Forum