Raspberry pi 5

  I am install linuxcnc 2.9.2 on raspberry pi5  and  I am  completing all  setting for Linux cnc lathe then I started linuxcnc and I found error and error picture I am also attached please see and guide me how to solve this problem 

As per:
linuxcnc.org/docs/html/drivers/hal_pi_gpio.html
7. Known Bugs

At the moment (2023-07-16) this driver only seems to work on Raspbian as the generic Debian image does not set up the correct interfaces in /dev/gpiomem and restricts access to the /sys/mem interface.

Thanks for reply sir please tell now what is solution of this problem

Don't use screen shots taken at a bad angle impossible to read. Copy and paste the text only.

JT

 Thanks for reply sir i am attached error please see

try where username should be PI or whatever user name you are using.

Thanks for reply, sirI am already add user rohit to group gpio but same error show.

The error is
HAL_PI_GPIO: can't open /dev/gpiomem: 2 - No such file or directory

/dev/gpiomem doesn't exist

A replied previously
At the moment (2023-07-16) this driver only seems to work on Raspbian as the generic Debian image does not set up the correct interfaces in /dev/gpiomem and restricts access to the /sys/mem interface.

So have will have to start with a Raspbian image, build & install a rt kernel and then build & install linuxcnc.

But just for completeness can you run
and report the result

This problem was already known:
forum.linuxcnc.org/9-installing-linuxcnc...-pi-5?start=0#285243
My advice is to use this new module (hal_gpio) which, in addition to working on Pi 5, in my opinion is more versatile and easier to configure

For changes to be made to .hal files it may be useful to refer to this video
forum.linuxcnc.org/9-installing-linuxcnc...i-5?start=110#290838

Many thanks.