Change from axis to gmoccapy

I have a working cnc setup with stepconf wizard but i want to change from axis to gmoccapy.
Is there a tutorial what config changes needed to make gmoccapy work ?

The Gmoccapy chapter in the manual.

JT

just about change the ini file from axis to gmocappy should do
other than minimal changes in your ini file , see examples in sim for gmacoppy and amend as appropratly
if you feel your not up to it post your config as an archive here , and i'll do the required changes if it helps

Here is my config...
If i change from axis to gmocappy it doesn't start

the archive you posted appears to be damaged , could you please check and upload again
extracting the files gives error

I have downloaded and seems ok to me exracting it with winrar.

this archive is still damaged please use tar gz archives , not windows archivers , they corrupt , passing files between linux and windows is fraught with problems
as the files are converted to windows cr/lf in some cases , use archiver in linux , and then pass the produced archive file to windows if needed , this preserves the files and their permissions .

ok i converted to tar.gz

thanks

update ;
iv'e got most of the conversion completed
although the vfd is going to need some work , and is where most of the conversion problems occour

cncbasher wrote: thanks

update ;
iv'e got most of the conversion completed
although the vfd is going to need some work , and is where most of the conversion problems occour

can you send me please without vfd ?