Asus Prime A520M-K No X Window system

More
4 years 2 months ago #248894 by ChathamDaleJ
 

Attachment not found

 

Attachment not found

 

Attachment not found

After installation, X fails to start, complains that it cannot open a framebuffer.

Graphics is onbard, Radeon HD 5880

I suspect the drivers for the graphics card are not being installed.

Help!!!!

Please Log in to join the conversation.

More
4 years 2 months ago #248906 by tommylight
What are you installing?

Please Log in to join the conversation.

More
4 years 2 months ago #248911 by ChathamDaleJ
LinuxCNC 2.8.2 Debian 10 Buster PREEMPT-RT ISO

Please Log in to join the conversation.

More
4 years 2 months ago #248915 by tommylight
At boot time, GRUB menu press E and add "nomodeset" after "splash", enter.
See if that makes it boot.

Please Log in to join the conversation.

More
4 years 2 months ago #248922 by ChathamDaleJ
"splash" does not appear in the grub configuration. I added at the end of the line starting with "linux".

Booted same problem.

Please Log in to join the conversation.

More
4 years 2 months ago #248938 by ChathamDaleJ
How flaky is the sid distribution from Debian and does it install with LinuxCNC ready to run?

Please Log in to join the conversation.

More
4 years 2 months ago #248953 by Todd Zuercher
The flakiness isn't so much in running. (It usually runs fine.) The flakiness is in the interaction of changing dependencies when ever an update or software installation is performed. You can never know if your system and all of it's parts will still work or even still be installed the next time you update.

Please Log in to join the conversation.

More
4 years 2 months ago #248971 by ChathamDaleJ
Is sid the only distribution containing LinuxCNC?

If so, is this the right link to install: mirrors.edge.kernel.org/debian/dists/sid...ller-amd64/20210731/

Thanks,

Dale

Please Log in to join the conversation.

More
4 years 2 months ago #249030 by Todd Zuercher
No, it is also in Testing (Bookworm). Or was last time I checked (I have it installed as such in a VM.)

Please Log in to join the conversation.

More
4 years 2 months ago #249092 by ChathamDaleJ
is there a relatively inexpensive graphics card know to work with LinuxCNC 2.8.2 out of the box?

Please Log in to join the conversation.

Time to create page: 0.761 seconds
Powered by Kunena Forum