inslaling ISO Linuxcnc 2.8.4

Hello All,

i am trying to instal Linuxcnc from USB iso
last Download form 6-10 15.30 
 
I Get a Erro wen the system wants to install

Installation step Failed

thats after the Installer wants to Coppy Data to the disk

IS a New PC prodesk 600 G2 Intel I3 Core

have has a sugestion for me?
 

What is the exact error?

this was de message in the screen

Was this at the end of installation?
If yes, disable "secure boot" in the PC's BIOS settings.

this was just (30 sec ) after starting installation.

before these step i have te chose about the disks

i have tryed it with secure boot disabled en legacy on. same problem.

is refus a good tool to make the iso on a SD card .

or do i use only usb stiks in stead of usb sd card reader?

Linuxcnc 2.9 is days from being released on Debian 12 Bookworm. Likely over this weekend.
Bookworm has much better support for Secure boot/UEFI
Please try my prerelease installer. It will probably solve your problem.
www.forum.linuxcnc.org/9-installing-linu...xcnc-x86-only#278427

Once you do a sudo apt upgrade, Linuxcnc will be right up to date as the last remaining issue has been resolved.

Thanks for the advies
I will try it tomorrow Dutch time

instalation went oke after i canhed from sd card to USB Stick.

now i am strugglinf wit my Pythom change dialog

first error was un rule 59. wen i comment that line next errorline was 75

do i have to change the ril 59 from    
print "change_prolog: Toolchanger soft fault %d" % int(self.params[5601]) to     
rint ("change_prolog: Toolchanger soft fault %d" % int(self.params[5601]))

wenn i edit the file in visual studio code the red under highlight is gone afte i Add ( and )

At a guess, your python script is Python 2.7. It needs to be Python 3 compliant today.
use the components supplied on the installation disk and you should be OK