Center Spot Sheetcam Post

Phill,

Do you have a center spot post processor for Sheetcam you could share? Or can we just select a drill tool in sheetcam and it will do the same thing? I guess we wont be able to use the PlasmaC built in function if we do that.

Do we need to create a tool to use the spot function like we did for the scribe? If so what parameter do we need to set?

Here you go, I think it is the same as the last one I posted.

You need either of Centre Spot or Center Spot somewhere in the tool name.
Probably have Pierce Height and Cut Height the same.
THC = disabled
Pierce Delay = 0
Cut Rate = really fast

EDIT: You also need to set the Torch On Time in the Config Panel

So in sheetcam can I set the spot up as a drill tool? As long as I am selecting the correct center spot tool?

I am not sure, I don't know what a drill tool is or does. I think I had it as a plasma tool.

Ill try drill tool and see how it goes.

Hit a bit of a snag updating my run in place config,



Usually I when I get that error I do git reset --hard and it works but not this time,

Any ideas Phil?

It looks like you have used the Sims and saved config changes.
If you don't need them do

Did not work,



What next?

Did you leave out the space dot after checkout.

I am on my phone and can't see clearly

I did but when back and did it again and still no luck.