HAL Question

Trying to get my ohmic power supply on a SSR that I have in my cabinet. I want to hook it to output-01 of my 7i76... I borrowed the ohmic stuff from Rod's Spaceship HAL file, and thought it was as easy as changing his output to fit my board.

IE:
However, the Hardware Abstraction Layer is something, despite Reading the Fing Manual, that remains... abstract to me.

I'm sure it's simple, but I can't see it. At any rate, I've attached my files. The ohmic stuff is in the plasma_connections.hal, but I attached the rest for good measure.

Thanks as always.

That looks correct
What is the issue?

PCW wrote: That looks correct
What is the issue?

It doesnt do anything, neither when I click ohmic test, nor probe test with ohmic enabled.

I even watched in the HAL Watch, and the output never changes states.

does ohmic:power change?

PCW wrote: does ohmic:power change?

it does not

OK so that's a Plasmac question

PCW wrote: OK so that's a Plasmac question

Copy that, thanks Peter

It might still be a HAL question, ( some input not working/connected righht etc )
but I don't know what plasmac needs to assert ohmic:power

PCW wrote: It might still be a HAL question, ( some input not working/connected righht etc )
but I don't know what plasmac needs to assert ohmic:power

In all honesty it could be something unique to rod’s table...

I think that is all part of the ohmic component.

This line: connects the plasmac.ohmic-enable output pin to the ohmic component. This pin should go True when you do an ohmic test. From there the ohmic component handles everything.