Jog buttons missing

Hi
I just noticed that all my jog buttons are missing. The step increment selection buttons are visible but no jog buttons. Any suggestions?

What GUI?

Sorry, Gmoccapy. I just assumed that everyone uses that

mariusl wrote: Sorry, Gmoccapy. I just assumed that everyone uses that

Not me, I use Axis.

I just tried then with a Run Panel and then with a Run Tab and works OK here. That is on a sim.

phillc54 wrote: Not me, I use Axis.

+1

My sim also has the jog buttons but not the installed run version. I did not add or change anything in the INI file.
I am sure that those buttons are standard for the Gmoccapy screen. Does the PlasmaC installation require any mods to the jog buttons?

mariusl wrote: My sim also has the jog buttons but not the installed run version. I did not add or change anything in the INI file.
I am sure that those buttons are standard for the Gmoccapy screen. Does the PlasmaC installation require any mods to the jog buttons?

No, none at all. Very odd...

Could you post your ini file.

Edit. I am testing on 2.8

Also on 2.8 so far I know.

Try changing:
to:
Edit. If you home the machine in the original format the buttons will show, it hides joint buttons.

That worked fine thanks. I dont know if I want to drive the slave Y axis in joint mode. The machine has only one limit switch fitted. I might have to redo the config.