toolsets

Hello, I need help with toolsets. I've added a toolset from the sticky to sheet cam and it appears to work. But when I add the same tool set to Plasmac they do not come across the same - almost everything is set to 1.0000. Thanks.

Can you post the plasmac materials file

See attached, torch all of the numbers seem off? torch height etc.

Can you post the sheetcom file?

attached

The tool file and the material file you posted match up with each other except for material #7.

The images you show do not correspond with the material file you posted.

When you saved this material file did you give it the correct name and did you put it in your config folder.

The file name should be <machine_name>_material.cfg

thanks for looking, yes saved in the same folder as the machine I use. I did put other toolsets in to see if they would work but the result is always the same when i lookin plasmac..

Can you post a zip of your config folder.

Attached

I think you need to run the materialverter again but you need to select imperial output.