manual tool change not working after update

I have updated to the latest stable version of probe basic via apt and suddenly the manual tool change does not work.
I have deleted the lines corresponding to the manual tool change as the guide says and it still does not work.

Can anyone have an idea of ​​what is failing?

You deleted all of the manual yotol change lines, look at that section of the docs again and add in the tool change lines still showing as active in the docs file, should get you back up and working. 

Lcvette wrote:

You deleted all of the manual yotol change lines, look at that section of the docs again and add in the tool change lines still showing as active in the docs file, should get you back up and working.
 

I have added the lines and still no tool loads. I have decided to create a new configuration that already loads the tools but suddenly without touching anything the program no longer opens and gives me an error.

I am very sorry for the inconvenience, I am very new to linuxcnc.

Remove the comment # for

HALUI = halui

In the ini

Lcvette wrote:

Remove the comment # for

HALUI = halui

In the ini
 

Thank you very much, that worked.

Now I have another problem that I didn't have before.... when I use the probe routine, and touch the 3D probe on the material, it stops and says error:
"Can't do g1
 with zero forward speed"

Add and update the probing parameter entries

Lcvette wrote:

Add and update the probing parameter entries
 

Forgive my ignorance, but what exactly are you referring to?

On the probing page,  the parameter boxes,  there is a new feed entry for traverse feedrate, make sure all of those have been entered and updated using the update probe parameters button

 

It's working now!!!! I was able to machine my first piece successfully, although due to a mistake on my part I broke the carbide cutter

Now I have another problem... the piece doesn't have the correct measurements.

In Z I should have gone down to Z-10 only and that's what probe basic indicated
but it went down to 15.8mm, I don't know why because when I tell it to go to Z-10 it goes down 10mm...

I attach the gcode that I used

Seems that you are using toollength compensation:
[code]N55 G43 Z15. H1[code]

So you might want to check the 'Z' value for Tool 1 in your tool table.

linuxcnc.org/docs/html/gcode/g-code.html#gcode:g43