development of a qt version of ncam

More
2 years 10 months ago #287571 by cmorley
development of a qt version of ncam was created by cmorley
Been slugging along with an ncam conversion and have a little success.
Long way to go. I can see a lot of work went into ncam!

Attachment not found

Please Log in to join the conversation.

More
2 years 10 months ago #287705 by andypugh
Replied by andypugh on topic development of a qt version of ncam
While you are at it... Do you see a more elegant way to display the stock than a set of rapids that are in an optional block? That was an ingenious hack, but runs the risk of actually being run. (Unless I am misunderstanding something)

Please Log in to join the conversation.

More
2 years 10 months ago #287711 by cmorley
Replied by cmorley on topic development of a qt version of ncam
I'm sure we could add magic comments to do it.

Please Log in to join the conversation.

More
2 years 10 months ago #288365 by cmorley
Replied by cmorley on topic development of a qt version of ncam
Little more updates...

Please Log in to join the conversation.

More
2 years 9 months ago #289901 by Roguish
Replied by Roguish on topic development of a qt version of ncam
the previous version of NCAM would pop a warning at you if ya tried to run with the 'stock' lines on. and would not run, until ya turned them off.
No clue how it was handled inside, but it worked.
Caught and saved me a number of times......

Chris, NICE WORK.

Please Log in to join the conversation.

More
2 years 9 months ago #290115 by Roguish
Replied by Roguish on topic development of a qt version of ncam
Chris,
where is this? and how is it installed?????

thanks.

Please Log in to join the conversation.

More
2 years 9 months ago #290146 by cmorley
Replied by cmorley on topic development of a qt version of ncam
Currently not available -it's just on my system- I think it's still to rough for anyone to use.
It will install with linuxcnc - it will be part of it.
I'll push it pretty soon - I don't want to lose the work if my machine crashes :)

Please Log in to join the conversation.

More
2 years 9 months ago #291337 by ikkuh
Replied by ikkuh on topic development of a qt version of ncam
I came across these:
github.com/LinuxCNC/simple-gcode-generators

Please Log in to join the conversation.

More
2 years 9 months ago #291446 by Roguish
Replied by Roguish on topic development of a qt version of ncam
yup. those have been around for years. they pretty good.

Please Log in to join the conversation.

More
2 years 9 months ago #291479 by blazini36
Replied by blazini36 on topic development of a qt version of ncam

I came across these:
github.com/LinuxCNC/simple-gcode-generators
 
Now that's handy

Please Log in to join the conversation.

Time to create page: 0.065 seconds
Powered by Kunena Forum