My first CNC - begged and borrowed all the way.

Hello all,

I browsed through the "Show Your Stuff" section and realised my machine is pretty small fry compared to some of your creations ! I am in awe!

However, somewhat humbled, I though I'd share my progress so far anyway. This project has cost me under £100 so far. I've managed to get the steppers from salvage - it's using 8mm lead screws. I 3D printed mounts and other parts as required.

Next step is to get the wiring / end stops etc done - thanks to BigJohnT for the support getting LinuxCNC installed.

I have no idea how capable it will be - but if it cuts wood and not my fingers it'll be a good start.

Nice for starters, for sure. When you see it moving, that is very satisfying and rewarding.
Regards,
Tom

Thanks for the encouragement Tom !

You are welcomed, always.

You're machine is looking good! Don't matter the size, just that you make it work for you. When you design the limit/home switches make them so you can't crash them.

My home made plasma in it's early stages. Notice the support structure (saw horses) lol.



JT

Thanks John,

My machine looks like its made of Lego compared to yours ! But hey - it's my first attempt - if this works I going to slowly build something bigger and more capable.

What did you mean about the limit switches ? I haven't got there yet - I was just going to print a holder for micro switches which will bolt onto the extrusion. Is there something I should watch out for ?

Regards

Julien

You want the limit switch design so you can't crash into them but rather pass over them if things mess up.

JT

Gotcha - thanks again John.

I think you have a great project going there. I have been in the build process for several years now. I had a test run yesterday and it got through that phase.

Just keep at it. There is a lot to learn in the whole process.

Good Luck.

Hi

I am completely new to this forum. Your build looks great. Any chance you might share drawings and parts lists ?