Profile for spinnaker

Offline

User Type: User
Rank: Senior Member

Register Date: 14 Jan 2016
Last login: 9 years 8 months ago
Time Zone: UTC +0:00
Local Time: 16:01

Posts: 47
Profile views: 7

Gender: Unknown
Birthdate: Unknown

spinnaker's recent posts (47 messages )

	Subject	Replies / Views	Last Post

	Inexpensive USB driver board? Arduino? Category: Driver Boards Topic started 9 years 8 months ago, by spinnaker Last Post 9 years 8 months ago by andypugh	Replies:4 Views:4130	Last Post by andypugh 9 years 8 months ago
	Stepconf encountered an error Category: StepConf Wizard Topic started 9 years 9 months ago, by spinnaker Last Post 9 years 6 months ago by andypugh	Replies:5 Views:2486	Last Post by andypugh 9 years 6 months ago
	Stepconf encountered an error Category: StepConf Wizard Topic started 9 years 9 months ago, by spinnaker Last Post 9 years 6 months ago by andypugh	Replies:5 Views:2486	Last Post by andypugh 9 years 6 months ago
	Stepconf encountered an error Category: StepConf Wizard Topic started 9 years 9 months ago, by spinnaker Last Post 9 years 6 months ago by andypugh	Replies:5 Views:2486	Last Post by andypugh 9 years 6 months ago
	The installer failed to access the mirror... Category: Installing LinuxCNC Topic started 9 years 9 months ago, by spinnaker Last Post 9 years 9 months ago by spinnaker	Replies:1 Views:3104	Last Post by spinnaker 9 years 9 months ago
	The installer failed to access the mirror... Category: Installing LinuxCNC Topic started 9 years 9 months ago, by spinnaker Last Post 9 years 9 months ago by spinnaker	Replies:1 Views:3104	Last Post by spinnaker 9 years 9 months ago
	Where is the "Live/Install" intall fo Ubuntu? Category: Installing LinuxCNC Topic started 9 years 10 months ago, by spinnaker Last Post 9 years 10 months ago by andypugh	Replies:2 Views:1710	Last Post by andypugh 9 years 10 months ago
	Where is the "Live/Install" intall fo Ubuntu? Category: Installing LinuxCNC Topic started 9 years 10 months ago, by spinnaker Last Post 9 years 10 months ago by andypugh	Replies:2 Views:1710	Last Post by andypugh 9 years 10 months ago
	Touching off on manual tool change? Category: General LinuxCNC Questions Topic started 10 years 8 months ago, by spinnaker Last Post 10 years 8 months ago by spinnaker 1 2	Replies:10 Views:6271	Last Post by spinnaker 10 years 8 months ago
	Touching off on manual tool change? Category: General LinuxCNC Questions Topic started 10 years 8 months ago, by spinnaker Last Post 10 years 8 months ago by spinnaker 1 2	Replies:10 Views:6271	Last Post by spinnaker 10 years 8 months ago

Time to create page: 0.989 seconds

Powered by Kunena Forum