Profile for galmiklos

Offline

User Type: User
Rank: New Member

Register Date: 10 May 2026
Last login: 2 months 6 days ago
Time Zone: UTC +0:00
Local Time: 10:59

Posts: 13
Profile views: 11

Gender: Unknown
Birthdate: Unknown

galmiklos recent posts (13 messages )

	Subject	Replies / Views	Last Post

	linuxcncrsh crashes when get_spindle or get_spindle_overide commands executed Category: Other User Interfaces Topic started 2 months 1 week ago, by galmiklos Last Post 2 months 6 days ago by galmiklos	Replies:3 Views:387	Last Post by galmiklos 2 months 6 days ago
	linuxcncrsh crashes when get_spindle or get_spindle_overide commands executed Category: Other User Interfaces Topic started 2 months 1 week ago, by galmiklos Last Post 2 months 6 days ago by galmiklos	Replies:3 Views:387	Last Post by galmiklos 2 months 6 days ago
	"Probe Height of the current tool" button not active in versatool Category: Qtvcp Topic started 3 months 1 week ago, by galmiklos Last Post 3 months 6 days ago by spicybagel	Replies:8 Views:720	Last Post by spicybagel 3 months 6 days ago
	"Probe Height of the current tool" button not active in versatool Category: Qtvcp Topic started 3 months 1 week ago, by galmiklos Last Post 3 months 6 days ago by spicybagel	Replies:8 Views:720	Last Post by spicybagel 3 months 6 days ago
	"Probe Height of the current tool" button not active in versatool Category: Qtvcp Topic started 3 months 1 week ago, by galmiklos Last Post 3 months 6 days ago by spicybagel	Replies:8 Views:720	Last Post by spicybagel 3 months 6 days ago
	"Probe Height of the current tool" button not active in versatool Category: Qtvcp Topic started 3 months 1 week ago, by galmiklos Last Post 3 months 6 days ago by spicybagel	Replies:8 Views:720	Last Post by spicybagel 3 months 6 days ago
	Cannot get out of Estop Category: General LinuxCNC Questions Topic started 4 months 1 week ago, by galmiklos Last Post 4 months 6 days ago by tommylight	Replies:5 Views:537	Last Post by tommylight 4 months 6 days ago
	Cannot get out of Estop Category: General LinuxCNC Questions Topic started 4 months 1 week ago, by galmiklos Last Post 4 months 6 days ago by tommylight	Replies:5 Views:537	Last Post by tommylight 4 months 6 days ago
	Cannot get out of Estop Category: General LinuxCNC Questions Topic started 4 months 1 week ago, by galmiklos Last Post 4 months 6 days ago by tommylight	Replies:5 Views:537	Last Post by tommylight 4 months 6 days ago
	Cannot get out of Estop Category: General LinuxCNC Questions Topic started 4 months 1 week ago, by galmiklos Last Post 4 months 6 days ago by tommylight	Replies:5 Views:537	Last Post by tommylight 4 months 6 days ago

Time to create page: 0.091 seconds

Powered by Kunena Forum