;     file name: Holes_Mesa 7i76e.ngc
; date and time: Tue Jul 21 2020    22:20:10
; postprocessor: PlasmaC_F.scpost rev: F
;
;begin pre-amble
 G21 (units: metric)
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M52 P1 (adaptive feed: on)
 M65 P2 (enable THC)
 M65 P3 (enable torch)
 M68 E3 Q0 (velocity 100%)
 G64 P0.254 Q0.025 (tracking tolerances: 0.254mm)
 F#<_hal[plasmac.cut-feed-rate]>
;end pre-amble
;
;begin material setup
 M190 P2 (centre spot material)
 M66 P3 L3 Q2 (wait for valid change)
 F#<_hal[plasmac.cut-feed-rate]>
;end material setup
;
;begin mesa 7i76e #1, spotting
 G0 X3.810 Y3.810
 M3 $2 S1 (spot start)
 G91 (relative distance mode)
 G1 X0.000001 (tiny move)
 G90 (absolute distance mode)
 M5 $2(spot stop)
;end mesa 7i76e, spotting #1
;
;begin mesa 7i76e #2, spotting
 G0 X10 Y4
 M3 $2 S1 (spot start)
 G91 (relative distance mode)
 G1 X0.000001 (tiny move)
 G90 (absolute distance mode)
 M5 $2(spot stop)
;end mesa 7i76e, spotting #2
;
;begin mesa 7i76e #3, spotting
 G0 X20 Y4
 M3 $2 S1 (spot start)
 G91 (relative distance mode)
 G1 X0.000001 (tiny move)
 G90 (absolute distance mode)
 M5 $2(spot stop)
;end mesa 7i76e, spotting #3
;
;begin mesa 7i76e #4, spotting
 G0 X30 Y4
 M3 $2 S1 (spot start)
 G91 (relative distance mode)
 G1 X0.000001 (tiny move)
 G90 (absolute distance mode)
 M5 $2(spot stop)
;end mesa 7i76e, spotting #4
;
;
;begin post-amble
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M65 P2 (enable THC)
 M65 P3 (enable torch)
 M68 E3 Q0 (velocity 100%)
 M5 $-1 (backup stop)
;end post-amble
;
;begin statistics
;  Spots = 20
;end statistics
;
 M30 (end program)