ETH device 7I76E-16 at ip=10.10.10.10
Communication:
  transport layer: ethernet IPv4 UDP
  ip address: 10.10.10.10
  mac address: 00:60:1B:10:41:2B
  protocol: LBP16 version 3
Board info:
  Flash size: 16Mb (id: 0x14)
  Connectors count: 3
  Pins per connector: 17
  Connectors names: on-card P1 P2
  FPGA type: 6slx16ftg256
  Number of leds: 4
Board firmware info:
  memory spaces:
    0: HostMot2 (registers, RW, 32-bit) [size=64K]
    1: KSZ8851 (registers, RW, 16-bit) [size=256]
    2: EtherEEP (EEPROM, RW, 16-bit) [size=128], page size: 1, erase size: 1
    3: FPGAFlsh (flash, RW, 32-bit) [size=16M], page size: 256, erase size: 65536
    4: Timers (memory, RW, 16-bit) [size=16]
    6: LBP16RW (memory, RW, 16-bit) [size=16]
    7: LBP16RO (memory, RO, 16-bit) [size=16]
  [space 0] HostMot2
  [space 2] Ethernet eeprom:
    mac address: 00:60:1B:10:41:2B
    ip address: 10.10.10.10
    board name: 7I76E-16
    user leds: eth debug
  [space 3] FPGA flash eeprom:
    flash size: 16Mb (id: 0x14)
  [space 4] timers:
    uSTimeStampReg: 0x2449
    WaituSReg: 0x0000
    HM2Timeout: 0x0000
  [space 6] LBP16 control/status:
    packets received: all 390, UDP 370, bad 0
    packets sended: all 372, UDP 370, bad 0
    parse errors: 0, mem errors 0, write errors 0
    error flags: 0x0000
    debug LED ptr: 0x0008
    scratch: 0x0000
  [space 7] LBP16 info:
    board name: 7I76E-16
    LBP16 protocol version 3
    board firmware version 16
    IP address jumpers at boot: fixed from EEPROM