%
( AXIS "splash g-code" Not intended for actual milling )
(Z axis)
( depending on your setup. As if you had some material in your mill... )
(Z axis down a bit then touch off )
( Also press the Toggle Skip Lines with "/" to see that part )
( If the program is too big or small for your machine, change the scale below )
( LinuxCNC 19/1/2012 2:13:51 PM )
#<depth>=2.0
#<scale>=1.0


#(BEGIN PREDATOR NC HEADER)
#(MACH_FILE=HAAS - 3XVMILL.MCH)
#(MTOOL T1 S1 D.125 H5. A0. C0. DIAM_OFFSET 1 = .0625)
#(SBOX X-1.0101 Y-.7197 Z-1. L2. W1.5 H1.)
#(END PREDATOR NC HEADER)

%
O100
(PROGRAM NUMBER)
(PROGRAM NAME - TEST0001.NC)
(POST -  FANUC 0M)
(DATE - SAT. 06/24/2017)
(TIME - 03:21PM)

N01 G90 G80 G40 G20 G17

N02 G00 G91 G28 Z0.
N03 G91 G28 X0. Y0.

(JOB 1  CONTOUR)
(FEATURE PROFILE)

N04 T01 M06
N05 S1497 M03
N06 G90 G54 X-.0101 Y-.6572
N07 G43 H01 Z.1 M08
N08 G01 Z-.5 F3.5936
N09 X.9274 F5.9893
N10 Y.7178
N11 X-.9476
N12 Y-.6572
N13 X-.0101
N14 G00 Z.1

(JOB 1  CONTOUR)
(FEATURE PROFILE)

N15 S1497
N16 X-.1149 Y-.2183
N17 G01 Z-.5 F3.5936
N18 X-.0994 F5.9893
N19 Y-.1873
N20 X-.1304
N21 Y-.2183
N22 X-.1149
N23 G00 Z.1

(JOB 1  CONTOUR)
(FEATURE PROFILE)

N24 S1497
N25 X.1349 Y-.2086
N26 G01 Z-.5 F3.5936
N27 G17 G02 X.1349 Y-.2086 I-.2457 J0. F5.9893
N28 G00 Z.1

(JOB 1  CONTOUR)
(FEATURE PROFILE)

N29 S1497
N30 X.4055 Y.3089
N31 G01 Z-.5 F3.5936
N32 X.421 F5.9893
N33 Y.3399
N34 X.39
N35 Y.3089
N36 X.4055
N37 G00 Z.1

(JOB 1  CONTOUR)
(FEATURE PROFILE)

N38 S1497
N39 X.6536 Y.3183
N40 G01 Z-.5 F3.5936
N41 G02 X.6536 Y.3183 I-.246 J0. F5.9893
N42 G00 Z.1
N43 M09
N44 M05
N45 G91 G28 Z0.
N46 G91 G28 X0. Y0.
N47 T01 M06

(END OF PROGRAM)

N48 M30
%