wwp@wwp:~$ linuxcnc
LINUXCNC - 2.8.0
Machine configuration directory is '/home/wwp/linuxcnc/configs/NativeCAM-master/configs/sim/axis/ncam_demo.2.8'
Machine configuration file is 'mill.ini'
Starting LinuxCNC...
emc/iotask/ioControl.cc 702: can't load tool table.
Found file(lib): /usr/share/linuxcnc/hallib/core_sim.hal
Note: Using POSIX realtime
Unexpected realtime delay on task 0 with period 1000000
This Message will only display once per session.
Run the Latency Test and resolve before continuing.
Found file(lib): /usr/share/linuxcnc/hallib/simulated_home.hal
Unexpected realtime delay on task 0 with period 1000000
This Message will only display once per session.
Run the Latency Test and resolve before continuing.

note: MAXV     max: 1.500 units/sec 90.000 units/min
note: LJOG     max: 1.500 units/sec 90.000 units/min
note: LJOG default: 0.250 units/sec 15.000 units/min
note: jog_order='XYZ'
note: jog_invert=set([])

(gladevcp:1531): libglade-WARNING **: 13:51:22.708: could not find glade file 'ncam.ui'
**** GLADE VCP ERROR:    With xml file: ncam.ui : could not create GladeXML object

<commandline>:0: gladevcp exited without becoming ready
Embeded tab command "halcmd loadusr -Wn gladevcp gladevcp -c gladevcp -x 48234638 -U --catalog=mill ncam.ui" exited with error: 1
Shutting down and cleaning up LinuxCNC...
task: 2772 cycles, min=0.000066, max=0.008623, avg=0.001142, 0 latency excursions (> 10x expected cycle time of 0.001000s)
Note: Using POSIX realtime
LinuxCNC terminated with an error.  You can find more information in the log:
    /home/wwp/linuxcnc_debug.txt
and
    /home/wwp/linuxcnc_print.txt
as well as in the output of the shell command 'dmesg' and in the terminal
wwp@wwp:~$