wp@wwp:~$ linuxcnc LINUXCNC - 2.9.0~pre1+git20230208.f1270d6ed7 Machine configuration directory is '/home/wwp/linuxcnc/configs/my-mill101423' Machine configuration file is 'my-mill101423.ini' Starting LinuxCNC... linuxcnc TPMOD=tpmod HOMEMOD=homemod EMCMOT=motmod Note: Using POSIX realtime Found file(REL): ./my-mill.hal config string '0 out' Found file(REL): ./custom.hal note: MAXV max: 5.000 units/sec 300.000 units/min note: LJOG max: 5.000 units/sec 300.000 units/min note: LJOG default: 0.500 units/sec 30.000 units/min note: jog_order='XYZ' note: jog_invert=set() ignoring M2 after endsub ::ttt::embedinit:Note truetype-tracer v4 is required ::ttt::embedinit:wrong version of truetype-tracer task: main loop took 0.135323 seconds ^[[Dtask: main loop took 0.109426 seconds Shutting down and cleaning up LinuxCNC... task: 20397 cycles, min=0.000010, max=0.135323, avg=0.010070, 2 latency excursions (> 10x expected cycle time of 0.010000s) Note: Using POSIX realtime wwp@wwp:~$