; test square hole.tap   30/09/2019   18:25:06
; postprocessor: NewLinuxCNC_Post.scpost
;
 G20 (units: inches)
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M52 P1 (adaptive feed: on)
 G64 P0.01 Q0.001 (tracking tolerances: 0.01")
 F#<_hal[plasmac.cut-feed-rate]>
;
 M190 P4 (14 guage steel material)
 M66 P3 L3 Q2  (wait for valid change)
;
 F#<_hal[plasmac.cut-feed-rate]>
;
 (start test square #1 torch, 4.89")
 G0 X1.93000 Y1.50000
 M3 $0  S1
 G1 X2.23000 Y1.50000
 G3 X2.23000 Y1.50000 I-0.73000 J-0.00000
 M5
 (end test square #1  torch)
;
 M190 P1 (1/8 steel material)
 M66 P3 L3 Q2  (wait for valid change)
;
 F#<_hal[plasmac.cut-feed-rate]>
;
 (start test square #2 torch, 12.30")
 G0 X0.60417 Y-0.22155
 M3 $0  S1
 G3 X0.41217 Y-0.02955 I-0.19200 J0.00000
 G1 X0.11083 Y-0.02955
 G2 X-0.02955 Y0.11081 I-0.00029 J0.14009
 G1 X-0.02955 Y2.88917
 G2 X0.11083 Y3.02955 I0.14011 J0.00027
 G1 X2.88917 Y3.02955
 G2 X3.02955 Y2.88917 I0.00027 J-0.14011
 G1 X3.02955 Y0.11081
 G2 X2.88917 Y-0.02955 I-0.14009 J-0.00027
 G1 X0.41217 Y-0.02955
 M5
 (end test square #2  torch)
;
(Pierces = 2)
(Cuts = 2   Length = 17.18")
;
 G40 (cutter compensation: off)
 G90 (distance mode: absolute)
 M5 (plasmac stop)
 M30 (end program)