cnc@cnc:~/linuxcnc/configs/TEST_MATRIX_KB$ sudo mesaflash --device 7i92 --addr 10.10.10.10 --sserial
[sudo] password for cnc: 
SSLBP port 0:
  SSLBP Version: 1.43
  SSLBP Channels: 6
  SSLBP Baud Rate: 2500000
  sserial device at channel 0: 7I77 GPIO (unit 0x12000A72)
    SwRevision = 14
    NVBaudRate = 2.5Mb
    NVUnitNumber = 0x12000A72
    NVWatchDogTimeout = 50ms
    SOFTWARE MODE Input_Output [index 00]
    SOFTWARE MODE IO_Analog [index 01]
    SOFTWARE MODE IO_Analog_FieldVoltage [index 02]
    SOFTWARE MODE IO_Encoder_Analog_Fieldvoltage [index 03]
  sserial device at channel 1: 7I77 ANALOG (unit 0x11000A72)
    SwRevision = 14
    HwRevision = 1
    NVBaudRate = 2.5Mb
    NVUnitNumber = 0x11000A72
    NVWatchDogTimeout = 50ms
    SOFTWARE MODE AnalogOut_Enables [index 00]
  sserial device at channel 2: 7I73 (unit 0x130001AE)
    SwRevision = 14
    HwRevision = 1
    NVBaudRate = 2.5Mb
    NVUnitNumber = 0x130001AE
    NVWatchDogTimeout = 50ms
    SOFTWARE MODE InputOutputEncoder [index 00]
    SOFTWARE MODE InputOutputEncoderAnalog [index 01]
    SOFTWARE MODE InputOutputEncoderAnalog [index 02]
    SOFTWARE MODE InputOutputEncoderDisplay [index 00]
    SOFTWARE MODE InputOutputEncoderAnalogDisplay [index 01]
    SOFTWARE MODE InputOutputEncoderAnalogWideDisplay [index 02]
    SOFTWARE MODE InputOutputEncoderKeycode4by8 [index 00]
    SOFTWARE MODE InputOutputEncoderAnalogKeycode4by8 [index 01]
    SOFTWARE MODE InputOutputEncoderAnalogKeycode4by8 [index 02]
    SOFTWARE MODE InputOutputEncoderDisplayKeycode4by8 [index 00]
    SOFTWARE MODE InputOutputEncoderAnalogDisplayKeyCode4by8 [index 01]
    SOFTWARE MODE InputOutputEncoderAnalogWideDisplayKeyCode4by8 [index 02]
    SOFTWARE MODE InputOutputEncoderKeycode8by8 [index 00]
    SOFTWARE MODE InputOutputEncoderAnalogKeyCode8by8 [index 01]
    SOFTWARE MODE InputOutputEncoderAnalogKeyCode8by8 [index 02]
    SOFTWARE MODE InputOutputEncoderDisplayKeycode8by8 [index 00]
    SOFTWARE MODE InputOutputEncoderAnalogDisplayKeyCode8by8 [index 01]
    SOFTWARE MODE InputOutputEncoderAnalogWideDisplayKeyCode8by8 [index 02]
cnc@cnc:~/linuxcnc/configs/TEST_MATRIX_KB$