ETH device 7I80HD-25 at ip=10.10.10.10
Communication:
  transport layer: ethernet IPv4 UDP
  ip address: 10.10.10.10
  mac address: 00:60:1B:11:80:22
  protocol: LBP16 version 2
Board info:
  Flash size: 16Mb (id: 0x14)
  Connectors count: 3
  Pins per connector: 24
  Connectors names: P1 P2 P3
  FPGA type: 6slx25ftg256
  Number of leds: 4
Board firmware info:
  memory spaces:
    0: HostMot2 (registers, RW, 32-bit) [size=64K]
    1: KSZ8851 (registers, RW, 16-bit) [size=256]
    2: EtherEEP (EEPROM, RW, 16-bit) [size=128], page size: 1, erase size: 1
    3: FPGAFlsh (flash, RW, 32-bit) [size=16M], page size: 256, erase size: 65536
    6: LBP16RW (memory, RW, 16-bit) [size=16]
    7: LBP16RO (memory, RO, 16-bit) [size=16]
  [space 0] HostMot2
  [space 2] Ethernet eeprom:
    mac address: 00:60:1B:11:80:22
    ip address: 10.10.10.10
    board name: 7I80HD-25
    user leds: eth debug
  [space 3] FPGA flash eeprom:
    flash size: 16Mb (id: 0x14)
  [space 6] LBP16 control/status:
    packets received: all 443, UDP 385, bad 0
    packets sended: all 402, UDP 385, bad 0
    parse errors: 0, mem errors 0, write errors 0
    error flags: 0x0000
    debug LED ptr: 0x0008
    scratch: 0x0000
  [space 7] LBP16 info:
    board name: 7I80HD-25
    LBP16 protocol version 2
    board firmware version 13
    IP address jumpers at boot: fixed from EEPROM