Is sheetcam dying?

10 Jun 2019 07:20 #136442 by pl7i92
Replied by pl7i92 on topic Is sheetcam dying?
and keep in mind that the Table zero is only the g-code zero
so you can place it all over the Table on the real machine

use the Standard G54

i got on one plasma the full table to the homing sequence so i can go with placing all parts on the sheets as most is full size sheet
for oven or swedenfirer series
so only homing and give it a run

Please Log in or Create an account to join the conversation.

Time to create page: 0.082 seconds
Powered by Kunena Forum