2+2+3 More Plasma builds, double the joy ! 3X2M and 2.5X1.5M cnc plasma build.

rodw wrote:

bbsr_5a wrote:

why the expensive AL profiles not a cheep Square steelbody 3mm wall 2x2"

1. Weight
2. I bet Tommy gets it cheap!

3mm steel is way over kill and heavy!

1 correct
2 not at all, at 3.7 euro/kg and 3.9kg/m anything but cheap!
But in the machine cost, that is quite a small price for the gantry and all the moving parts.
Since this situation is causing a lot of trouble getting anything done, i do have 80X80mm metal profile outside rusting at 6m length, so i might just use that. I would not like it.

Here is a short video of the gantry moving at 55meters per minute, or at 2165.3 inches per minute !
I did not dare to push it further out of fear it would fly away !
That is 1 meter distance it is passing in just a smidge above 1 second!
Acceleration is set at 1500mm/s/s, and this is possible using Mesa 7i92, Lam Technologies drives, an old beat up Lenovo laptop, and Sanyo-Denki 1.8A motors.

Regards,
Tom.

Surfing the gantry !
A failed attempt at doing just that, at such high acceleration it just throws me off on direction changes.

Ds1044 and DS1076, mostly.
I have no words to describe how good they are, but pricey !!!
mechapro.de had a discount on those two models last time i ordered 7 of them.
www.mechapro.de/shop/Schrittmotor-Steuer...ehaeuse:::22_49.html
Still the lowest price i could find.
-
So the sensors are wired and working, done it's first homing and squaring.... about 200 times !
While i was setting it up it was painfully slow, but after sorting it i raised the speeds, a lot! Makes for a fun thing to watch when 20cm from home, it's like "zip" done.
And just in case you order those, please be sure to order the programmer for them, it's 28 Euro, or you will be stuck at 1A and 2A respectively and at /4 microstepping. Been there done that ! First time i ordered them from an Italian website they never mentioned or suggested i might need that, i was stuck at default for nearly 5 months.

rodw wrote:

Awesome tommy. Can you share the lam technologies part numbers? I see 2 different sized boxes. Is one of them a power supply? What voltage are you using for the steppers.?

These are power supplies, bottom thingies, 3 of them, 400W each at 24V, wired in series for 72V to the big drives and 48 for the smal one. 1.2KW of power, add two more and i could use them for plasma cutting at 16.7A !!!

Sorry, forgot to attach the picture, to much math and everything...