Move on extents

So this is possible! :woohoo:
Big thanks ArcEye! Ill try use this on my AXIS configuration.

There was something corrupt in the previous zip.

This one opens properly

Hi.

I'v used another way to get my data.
I wrote this linuxcnc.org/index.php/english/forum/41-...es-pin-in-axis#57846 to .axisrc (removing unwanted data, Z axis)

Then i edited .INI config to get HAL pins from GCode (ENABLE = 8 at [RS274NGC] section)
linuxcnc.org/docs/html/remap/structure.h...d_sub_ini_features_a

  this working on LinuxCNC/AXIS Version 2.9.0~pre0Simply copy to /bin/ folder          rename it axis.py --> axis
make executable