Manual (keyboard) jog speed for milling

Hi.
Is there a way to set value for manual jog speed (Axis 2.7.4)?
Sometimes i want to mill by hand, but cant set exact value using jog speed slider

Cant find hal pin for slider value...

You can set it with a Halui pin.
halui.jog-speed
Never mind that doesn't' seem to work for keyboard jogging in axis. (It only sets the jog rate when using the halui pins for the inputs.)

No, halui.jog-speed don't work - checked before post this question here.
Thx for trying.

FiliP wrote: Sometimes i want to mill by hand, but cant set exact value using jog speed slider

It is probably easier (and better) to use MDI, that is what I typically do.
I quite often drill with the jogwheel, though, and you might prefer to fit one of those for hand operations.