JA homing and teleop

As far as i have experienced, master will not wirk with Ubuntu 10.04!!

Master needs python 2.7 and that is not availiable on Ubuntu 10.04. At least i did not find a solution to that problem!

Norbert

I don't think it is required, at least not when running Master installed from buildbot. I just now installed it from an old Ubuntu 10.04 Linuxcnc live CD on a VM, changed the Ubuntu repos to old-releases, added the Linuxcnc buildbot repos for Master in synaptic, updated the system, and Master 2.8pre was there and ran. (YMMV) Maybe it is required for Gmocapy??? but not for Axis like I just tested.

I only tried building from source, never used buildbot.

It is not requiered for gmoccapy.

Norbert

There are lots (and lots and lots) of dependencies that are required to build from source that you don't need to just run the binaries. (You probably have to have the same ones to compile 2.7 from source.)