TCP 5-axis kinematics

I tried to put version 2.9 on Dabian with "synaptic" but frankly I do not understand much.
I managed to erase v2.8 another version is installed but unable to launch. it's hard ..

what are you doing with all this ??
exemples :Buster (arch: amd64)
uspace: realtime with RT-Preempt, and simulationdeb buildbot.linuxcnc.org/ buster master-rtpreemptdeb-src buildbot.linuxcnc.org/ buster master-rtpreemptStretch (arch: amd64, i386)
uspace: realtime with RT-Preempt, and simulationdeb buildbot.linuxcnc.org/ stretch master-rtpreemptdeb-src buildbot.linuxcnc.org/ stretch master-rtpreempt

Ok have a look at this for your official ISO which is based on debian "buster": (start at 0:50 and remember to Type Buster instead of Stretch in the "Distribution" space)




[edit]
from that list you choose your Version of debian (ie "buster" for the official ISO). Then on the left you get the two lines you need to add to your repository:

I just tried this on buster and it doesn't seem to work without the key.

Not sure what is going on with buildbot.

Ok I think I have found a key that works.

So please run this in a terminal and then add the repositories:

This is what you should get back:

Ok thank you very much for all these details and this video, I will try. But how do I integrate my 5-axis configuration into my files? .ini rt .hal

thank you

Copy your configuration folder into the "config" folder of the new installation.

So, on version 2.9pre that I have on Xubuntu, I just have to copy my Configuration files in the "Configs" & "ncfiles" folders?
I don't need that ?

#!/bin/bash
cd /home/jack/linuxcnc-dev/src
source ../scripts/rip-environment
cd ..
linuxcnc ./configs/5axescnc/5axescnc.ini

#!/bin/bash
cd /home/jack/linuxcnc-dev/src
source ../scripts/rip-environment
cd ..
linuxcnc ./configs/5axescnc/5axescnc.ini

That is the script for the launcher on the desktop for your rip install. If you get the deb install running using the repositories then you don't need that anymore.

I have a few questions, just to understand

deb buildbot.linuxcnc.org/ buster master-rtpreempt
deb-src buildbot.linuxcnc.org/ buster master-rtpreempt

buster is a Distribution ?
master-rtpreempt is a section ?