beltramidave wrote: I am still at Ver. 2.5, so I am guessing that it will not work.
Well, you won't be able to simply run the demo config as-is.
But, making the same changes to a 2.5 config ought to work.
In the INI file this part loads the table GUI:
Code:
# add GladeVCP panel where PyVCP used to live:
EMBED_TAB_NAME=Bending
EMBED_TAB_COMMAND= gladevcp -c bender -x {XID} -u bender.py bender.ui
bender.ui is the glade GUI, bender.py does the actions.
You could edit the UI with Glade to have the columns you want.
bender.py contains Python code that handles editing values and adding/removing lines in the table. This is also where file save / load would go, but it isn't currently there. Currently there is a bit of code in here that runs when the "start" button on the GUI is pressed, but it would probably be better if this was operated by a hardware button, which is fairly easy to do. When the "Start" button is pressed all that happens is that the g-code program bender.ngc is run. This could contain anything, and is quite possibly the only file (other than the INI) that would need to be changed to make this into a driller rather than a bender.
