Spindle control 7i76e

I am rebuilding a tiny router for PCB milling and I grabbed this motor and controller

www.amazon.com/gp/product/B01LNBOCDA/ref...ages01?ie=UTF8&psc=1

I want to be able to control the speed from linuxcnc

The controller takes 0-10 analog for speed control.

it looks like I should be able to just connect there 0-10 + and - lines to the spindle + and -

does this sound correct ?

Thank You
Calvin

Yes, that ought to work.

Thank You, I should be able to test this over the weekend

I'll update the thread even if it works, in case anyone in the future is ever interested

Thank You
Calvin

Yes, the three cables from speed goes to the MESA Card and I suggest not to bridge the Switch, you may connect the cables to the Spindle enable signal of the MESA Card.

Norbert

Just wanted to say thank you to everyone for the help

spindle works exactly as expected

the POT inputs are wired to the 7I76 and I used the spindle enable lines to turn it on and off



Thank You
C