plasma stepper config

More
7 years 2 months ago #141678 by getyers
plasma stepper config was created by getyers

Attachment not found

Please Log in to join the conversation.

More
7 years 2 months ago #141680 by pl7i92
Replied by pl7i92 on topic plasma stepper config
Hi
the THC you nee to do it by hand
i add a config as i do use this also
this are the lines responsable
Code:
loadrt thcud addf thcud servo-thread net spindle-cmd <= motion.spindle-speed-out net spindle-on <= motion.spindle-on => thcud.arc-ok thcud.torch-on net TorchUp thcud.torch-up <= parport.0.pin-15-in-not net TorchDown thcud.torch-down <= parport.0.pin-10-in-not net CurVel thcud.current-vel <= motion.current-vel setp thcud.requested-vel 15.0 setp thcud.vel-tol 8.0 setp thcud.correction-vel 0.001

Please Log in to join the conversation.

More
7 years 2 months ago #141683 by tommylight
Replied by tommylight on topic plasma stepper config

getyers wrote:

Attachment not found

This is a double post ! It looks like the same user but did not check.
Yup, same user.
There are already some replies to the original thread, but it was never answered by the original poster.

Is there a users manual for the board you are trying to wire ? That picture is not helpful.

Please Log in to join the conversation.

More
7 years 2 months ago #141685 by tommylight
Replied by tommylight on topic plasma stepper config
Original thread

www.forum.linuxcnc.org/plasma-laser/37007-diy-thc

Although it is not a DIY thc.

Please Log in to join the conversation.

More
7 years 2 months ago #141687 by tommylight
Replied by tommylight on topic plasma stepper config
Torch up - goes to input on BOB ( usually 12 )
Torch down - goes to input on BOB ( usually 10 )
ArcOK - goes to input on BOB (usually 11 )

If your plasma does not have the connector for torch on and a voltage divider, please ask someone else who is qualified to wire that.
That is very dangerous !!!

Please Log in to join the conversation.

Time to create page: 0.092 seconds
Powered by Kunena Forum