5 axis kinematics modules

Can you send me your configuration file?

Can you share you configuration file?

ross_dev wrote: Hi Andy

Looks like a rookie error, I had it in joint mode! It works fine once in world mode. Cheers!

How do you change the world and joint mode?

Profed81 wrote: How do you change the world and joint mode?

Shift + $
IIRC

Que necesito para que esa simulación mueva una máquina de verdad? Creo que debo agregar pins de paso y dirección, verdad?

Profed81 wrote: Que necesito para que esa simulación mueva una máquina de verdad? Creo que debo agregar pins de paso y dirección, verdad?

Esta simulación no trae cargado los módulos de kinematics?

I don't have my spanish hat on but I think you are trying to use a simulation config for a real machine.
Simulation configurations will not run a real machine because the inputs and outputs are simulated in the computer. The kinematics modules are loaded but all the signals stay inside of linuxcnc.
To run a real machine you need to create your own config that fits your attached hardware. So use "pncconfig" to create a basic configuration and then edit the created INI and HAL file in the directory that was created by pncconfig.