Error message axis.z.pos-cmd

I have reinstalled my Linuxcnc Debian 9 and Linuxcnc 2.9
I have taken from my old installation only the directory Config.
I have sample Screen 2.0 reinstalled myself to follow the instructions of Vers.by
I start the machine making a reference run
Then I change it on trial screen , I adjust the height of the button (39.50mm) and
Pressing the symbol for measuring the length I get an error message
Axis.z.pos-cmd
Where else do I have to make an attitude

Can you post a screen shot of the error, please?

Sorry
Error message
Named parameter #<_hal [axis.2.joint-pos-cmd]> not defined

hi
from 2.8 the pinnames have been renamed
you need to change to

And where do I have to change what?
In the macros everywhere is axis.z.pos-cmd

Edi_48 wrote: Sorry
Error message
Named parameter #<_hal [axis.2.joint-pos-cmd]> not defined

This could also be due to G-code access to HAL not being turned on.
(Making this default to "On" is on my list of things to do)

linuxcnc.org/docs/2.8/html/remap/remap.h...i_file_configuration