switchkins install advice

More
6 years 4 weeks ago #184662 by Mkcherni
Replied by Mkcherni on topic switchkins install advice
here is the terminal image in full again. i am still fumbling with linux

Attachment not found



cheers

Please Log in to join the conversation.

More
6 years 4 weeks ago #184663 by Mkcherni
Replied by Mkcherni on topic switchkins install advice
this may help to know where i am

Attachment not found

Please Log in to join the conversation.

More
6 years 4 weeks ago #184665 by Mkcherni
Replied by Mkcherni on topic switchkins install advice
Ok success.

Attachment not found


The cause of my problem was that i cut and paste the text from tutorial to the terminal. t
The line cd linuxcnc-dev/debian did not change the directory to debian. I had to separate the 2 by typing cd linuxcnc-dev then cd debian. Then everything worked as instructed.

Please Log in to join the conversation.

More
6 years 4 weeks ago #184669 by Mkcherni
Replied by Mkcherni on topic switchkins install advice
That is very very very cool big big thank you to all who developed this. I would never have thought this was possible at a hobby level. Amazing

Please Log in to join the conversation.

  • Profed81
  • New Member
  • New Member
More
5 years 10 months ago #190820 by Profed81
Replied by Profed81 on topic switchkins install advice
I do not understand how it could work, because the switchkins is for a tilt table, and your machine is a tilt spindle

Please Log in to join the conversation.

More
5 years 10 months ago #190838 by Aciera
Replied by Aciera on topic switchkins install advice
"switchkins" is NOT limited to any particular machine kinematics. Its LinuxCNC with the ability to switch the type of kinematic from within the gcode.

Please Log in to join the conversation.

  • Profed81
  • New Member
  • New Member
More
5 years 10 months ago #190840 by Profed81
Replied by Profed81 on topic consejos de instalación de llaves
What parameters should be adjusted for each machine?

Please Log in to join the conversation.

More
5 years 10 months ago #190844 by Aciera
Replied by Aciera on topic consejos de instalación de llaves

What parameters should be adjusted for each machine?


Not quite sure what you mean. If you want to switch the kinematics when using the switchkins branch you have to build it

www.panix.com/~dgarrett/stuff/s_kins_guide.txt


and then you can use M commands to switch the kinematics you have set up.

www.panix.com/~dgarrett/stuff/switchkins.html

Please Log in to join the conversation.

  • Profed81
  • New Member
  • New Member
More
5 years 10 months ago #190845 by Profed81
Replied by Profed81 on topic consejos de instalación de llaves

Attachment not found


Maxkins does not appear in the list

Please Log in to join the conversation.

  • Profed81
  • New Member
  • New Member
More
5 years 10 months ago #190846 by Profed81
Replied by Profed81 on topic consejos de instalación de llaves
But what I need is for mill type bridge with tilting spindle rotating in the z axis

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.065 seconds
Powered by Kunena Forum