additional probe inputs or configuration for tool height sensor ???

not to beat a dead horse, but. It would be nice to tie in outputs to the tool setter, is there a way to say when probe mode is turned on we set output on a pin? Which I can then set as the voltage for my tool setter and then when input is triggered and after it does the tool height process I can have that output turned off again so the tool height is no longer powered and no false trips will happen?

You could possibly use the HAL pin motion.motion-type

linuxcnc.org/docs/html/man/man9/motion.9.html#MOTION%20PINS

so value 4: Tool change would work right? How would I do a comparison if motion-type == 4 output 1 else 0?

have a look here :
forum.linuxcnc.org/qtvcp/49934-qtdragon-...d-remap-g38-2#279717