Probe screen v2 - malfunction?

Just to clarify, when you say "Probe screen v2" what are you referring to?

Is this: github.com/LinuxCNC/linuxcnc/tree/master...n-panels/versa-probe

Or some other probe screen?

Sorry, my mistake. It is probe screen 2.9 from verser-git.

But I have similar problem like Marcodi:

So whenever you are inside of the probe screen and you use the keyboard numbers 2-8 4-6 and 3-9. The machine starts moving in the appropriate direction without stopping until it hits a limit switch

Same happens with my machine. And also when using page up and down with the z axis.

It looks like it supports incremental jogging, which might be safer:
github.com/verser-git/probe_screen_v2/bl...probe_screen.py#L360

My guess would be that for some reason the button-release events are not calling the button-release routine.

Though it might be nothing to do with probe-screen directly at all. Do the keys you mention also jog in the UI you are using _without_ probe-screen?

Yes they also jog w/o probe screen. But then the axis stop when I release the button. Only in probe screen the axis don't stop.

This sounds like a problem with event handling, then. Probe-screen might be passing-through key-press events but not key-release events.

Do you see the same issue with probe-screen-ng? (nothing that probe-screen-v2 seems to be abandoned)

You could even try this one: github.com/andypugh/probe-screen-ng

But these might have the same problem, I know that I have not tried to specifically address the problem described.