Probe Basic 2.9 or 2.10 install

Can someone walk me through an install of the most current Probe Basic GUI? I have made multiple failing attempts. Is this GUI abandoned?

Chris

Install Bullseye XFCE
and run this script. Its been updated this week to account for the branching off of V 2.9 from master branch (2.10)
github.com/joco-nz/lcnc-bullseye-installer

Thank you. Successfully running the sim on debain 11 and LCNC 2.10

For anyone else using this method the script has an error and wouldn't install
Linuxcnc-uspace-dev. Fix below;

(After successful install completion, run the commands below to add "Linuxcnc-uspace-dev")
Run In terminal:
cd ~/dev/linuxcnc/
sudo -A dpkg -i linuxcnc-uspace-dev_2.10.0~pre0_amd64.deb

I tried following this and everything completed successfully (except for that last line of code you provided COlger81, it threw up an error telling me to SUDO_ASKPASS), but I don't see Probe Basic GUI anywhere.  Is the Probe GUI supposed to be available under "my configurations" when launching LCNC?

edit: I have bookworm, not bullseye