Remora RT1052 nvem pinouts

Hello 
Can anyone share remora pinouts for nvem RT1052 board? 
I'm trying to set limit switches by adding :

net X-min remora.input.00 => joint.0.home-sw-in joint.0.neg-lim-sw-innet Y-min remora.input.02 => joint.1.home-sw-in joint.1.neg-lim-sw-innet Z-min remora.input.04 => joint.2.home-sw-in joint.2.neg-lim-sw-in

To my hal, but without proper pinout diagram I'm not sure which pin is for remora.input.00 etc. 
I've tried by connecting like on drawing in attachment, unfortunately without success.
Also is estop and probe pin counted as a inputs or separately? 

If anyone would still look for pinouts, please see attached 

The config file for the NVEM has the information you are looking for.

github.com/scottalford75/Remora-RT1052-c...xCNC/nvem-rt1052.txt

Example:

{
"Thread": "Servo",
"Type": "Digital Pin",
"Comment": "IN01",
"Pin": "P4_26",
"Mode": "Input",
"Data Bit": 4,
"Invert": "True"
},

This is the IN01 input and it is remora.input.04 . The Data Bit key sets the Remora input number. You can either use the these numberings or change these to your liking.