How to Spindle Orientation using forward-reverse PWM signal using parallel port?

More
2 years 2 months ago #306957 by fery15sty
How to Spindle Orientation using forward-reverse PWM signal using parallel port? was created by fery15sty
Can anyone help me, How to Spindle Orientation using forward-reverse PWM signals using parallel port? 

I have connected the encoder signal to the spindle axis. and the encoder works fine, I can run rigid tapping. But I am confused about how to configure the spindle orientation to position the BT30 lock before toolchange..

Please Log in to join the conversation.

More
2 years 2 months ago #307161 by jpg
Replied by jpg on topic How to Spindle Orientation using forward-reverse PWM signal using parallel port?
Bonjour voici une configuration valide pour un tour , les spécifications pour Orient se trouvent dans "spindle hal " ( il n'y a pas le carrousel) 
le lien pour comprendre est ici:
forum.linuxcnc.org/10-advanced-configura...indle-activation-m19

 

Attachment not found

Please Log in to join the conversation.

More
2 years 2 months ago #307241 by fery15sty
Replied by fery15sty on topic How to Spindle Orientation using forward-reverse PWM signal using parallel port?
how many ppr encoder do you use?

Please Log in to join the conversation.

More
2 years 2 months ago #307246 by jpg
Replied by jpg on topic How to Spindle Orientation using forward-reverse PWM signal using parallel port?
Bonjour c'est un omron e6b2-cwz6c aliexpress , résolution 200 pr

Please Log in to join the conversation.

Time to create page: 0.263 seconds
Powered by Kunena Forum