How to configure this knob?

More
2 years 2 weeks ago #311890 by vibram
How to configure this knob? was created by vibram
Hello, 

​​​​I managed to get the pin correctly read in Hal show but I have no idea how to configure it as the knob is both for jog, feed, and manual movements. How would you proceed 


Thank you 
 

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
2 years 2 weeks ago #311893 by tommylight
Replied by tommylight on topic How to configure this knob?
How many wires? How is it wired? To what is it wired?

Please Log in to join the conversation.

More
2 years 2 weeks ago #311894 by vibram
Replied by vibram on topic How to configure this knob?
6 wires
As of today I received a value in linuxcnc from 1 to 31, from a Grey code. But what to do with this value?

Please Log in to join the conversation.

More
2 years 2 weeks ago #311909 by COFHAL
Replied by COFHAL on topic How to configure this knob?
How did you make the connection to receive those values?

Please Log in to join the conversation.

More
2 years 2 weeks ago #311910 by Benb
Replied by Benb on topic How to configure this knob?
Linuxcnc wiki has examples for wheels/pendants ..., have look at the section adding external controls.
wiki.linuxcnc.org/cgi-bin/wiki.pl
 

Please Log in to join the conversation.

More
2 years 2 weeks ago #311911 by COFHAL
Replied by COFHAL on topic How to configure this knob?
Use MUX_GENERIC and connect the output through a signal to halui.feed-override.counts and halui.jog-speed

Please Log in to join the conversation.

Time to create page: 0.096 seconds
Powered by Kunena Forum